Modeling 1 – Lesson 6

BaModeling1-altck to course overview « Lesson 5 Lesson 7 »

NX9: Holes & Datums

Tags: hole, datum plane, positioning

This lesson will introduce the tool hole. We will also have a closer look at datum planes, and some positioning tips.

Subtitles can be activated by using the CC-button in the video interface.

You can try doing the exercises below after you are done with this lesson. 

NX8: Holes & Datums

Tags: hole, datum plane, positioning

This lesson will introduce the tool hole. We will also have a closer look at datum planes, and some positioning tips.

Subtitles can be activated by using the CC-button in the video interface.

You can try doing the exercises below after you are done with this lesson.

 

Exercise 4-5

Model this assembly. Remember to create the three parts separately before putting them together in an assembly file. The bolt head with the hexagonal head can be simplified by making a cylinder. NV = 22 [mm] is the length from edge to edge (not corner to corner). The M14-specifications can be found by a simple google-search. You may also simply define the outter thread dimensions to 14mm. Make sure that the bolt will fit into the hole of the bottom block.

Bottom block dimensions: 50 x 70 x 25 [mm]

Oppgave4

Suggested Solution

Model this geometry by using sketch & extrude. You can use a datum plane to position the M12-hole using the Hole-tool.

Oppgave5

Suggested Solution

Submit a Comment

Your email address will not be published. Required fields are marked *

eight + twenty =