Modeling 1 – Lesson 4

BaModeling1-altck to course overview « Lesson 3 Lesson 5 »

NX9: Modeling Case – Bolt

Tags: Modeling case, bolt

In this modeling case, we are going to show you how to model a bolt. There will be a short repetition of sketch and extrude, as well as an introduction to the tools edge blend, chamfer and thread. 

Subtitles can be activated by using the CC-button in the video interface.

You can try doing the exercises below after you are done with this lesson.

NX8: Modeling Case – Bolt

Tags: Modeling case, bolt

In this modeling case, we are going to show you how to model a bolt. There will be a short repetition of sketch and extrude, as well as an introduction to the tools edge blend, chamfer and thread. 

Subtitles can be activated by using the CC-button in the video interface.

You can try doing the exercises below after you are done with this lesson.

 

Oppgave 1-3

Model this by using sketch & extrude. 

Oppgave1

Løsningforslag

Model this by using  sketch & extrude.

Oppgave2

Suggested Solution

Modeller this by using sketch & extrude. 

Block dimensions: 60 x 90 x 30 [mm]

Slot dimensions:  44 x 90 x 12 [mm]

Oppgave3

Suggested Solution

Submit a Comment

Your email address will not be published. Required fields are marked *

19 − 16 =